WMF 5 Mode D'emploi page 60

Troubleshooting measures
Cannot lock the pad
cartridge.
Coffee strength is not
sufficient.
Cups left and right are filled
unevenly.
Filling quantity is gradually
getting smaller and smaller.
Coffee does not have any
crema.
28
Problem
Has the coffee pad been incorrectly inserted (see Fig. 3)?
> Check to see whether the coffee pad has been correctly inserted into the pad
cartridge.
> When using 2 coffee pads, press the lower one into the recess.
> Press on the coffee pad so that there is a small recess in the middle of it.
Has the coffee pad been incorrectly inserted (see Fig. 3)?
> Check to see whether the coffee pad has been correctly inserted into the pad
cartridge.
Minor differences in filling levels are impossible to avoid entirely. The machine's
performance improves with extended use.
Is the installation surface flat?
> Place the coffee pad machine onto a level installation surface.
Always turn the adjusting knob
> At regular intervals, check that the central opening of the pad cartridge is free
to avoid blockages.
> Descale the coffee pad machine in good time.
> Check to ensure that the suction cap is fitted securely to the floor of the water
tank. The suction cap still needs to be fitted securely even if you are not using a
water filter.
> Perform a rinse to remove air underneath the suction cap.
The coffee pad machine starts producing optimal quality of its crema once you have
used it a few times.
Does the strainer need descaling?
> Please read Section 5.3.1 "Coffee dispensing cartridge with strainer" on page 21
> Clean and descale the strainer at regular intervals.
Troubleshooting measure
B
to the right as far as possible.