WMF 5 Mode D'emploi page 58

Looking after your coffee pad machine
>
Descaling
>
Once the descaling program has started, the x2 button will light up continuously in red. After around 20
minutes, the first phase of the descaling program ends. The ready indicator flashes red; the x2 button
lights up in red again.
>
Rinsing
>
The ready indicator flashes red; the x2 button continues to light up in red.
>
>
>
Rinsing begins.
>
After rinsing a second time, the appliance automatically switches to the Off state.
>
>
>
26
Switch on the appliance, using the On/Off button
After switching the appliance on, keep the x2-button
will start running.
Rinse out the water tank before filling it with 1 litre of tap water- but no more than the capacity
of the catch basin.
Replace the water tank into the appliance.
Place the emptied catch basin underneath the spouts again.
B
Turn the adjusting knob to position
Press one of the two cup buttons
Once the ready indicator starts to flash red again, rinse once again. Repeat the above steps. Do so
by turning the adjusting knob to position
Turn the adjusting knob back to the home position
Reinsert the water filter back, as shown in section "Inserting the water filter (see Fig. 7)" on
page 10 (see Fig. 7).
We recommend that you wash the pad cartridge, coffee dispensing cartridge and strainer in the
dish washer after descaling.
H
.
D
down for approx. 5 seconds. The pump
.
E G
or .
.
when no more liquid is being dispensed.