Kermi Ideos Instructions D'utilisation Et De Montage page 7

Preinstall the bottom spacer (see Fig. 14)
Preinstall the setscrews in the spacer sleeve.
►
Push the spacer sleeve with the slot to the
►
bottom onto the spacer bolt and if neces-
sary lock into position with setscrews.
Install both spacers on the radiator.
►
Mount the radiator and align (see Fig. 15–19)
When aligning, take the position of the con-
necting pipes into account. Both compression
fittings must be able to be screwed onto the
converter's thread without any difficulty and
tensioning on the connecting pipes must be
avoided.
Put two compression fittings (not included
►
in the delivery) onto the connecting pipes.
Hook the radiator onto the holders past the
►
screws. In doing so make sure that the ra-
diator locks into place.
To align the radiator laterally: Adjust the
►
holders.
To adjust the wall spacing: Pull out or push
►
in the holders.
To adjust the height: Turn the adjusting
►
screw on the holder.
Install the bottom spacer and mount the
radiator (see Fig. 20–30)
Slide the bottom spacers out until they bear
►
on the wall and the radiator hangs straight.
Tighten the top lock screws.
►
Mark the bottom drill holes for the spacers.
►
Push the locking clip toward the rear and
►
unhook the radiator. Position the radiator
in such a way that the thermostatic head
and the heating element (IDV11) are not
damaged.
► Drill the holes at the bottom markings and
put the dowels in position.
Detach both spacers from the radiator.
►
Fasten both spacers in place on the wall by
►
screws.
Hook the radiator onto the holders past the
►
screws. In doing so make sure that the ra-
diator locks into place.
Press both cover caps on and push toward
►
the rear.
Fasten both spacers in place on the wall by
►
setscrews.
Connection (see Fig. 31)
Fasten both compression fittings in place by
►
screws.
Final tasks (see Fig. 32)
► Cover the radiator with the protective
packaging completely.
Commissioning
Remove protective packaging completely
►
for final cleaning or prior to commission-
ing.
► Fill the radiator and ventilate via the air
vent (E). Risk of scalding!
► Check radiator and connections for tight-
ness.
Electrical connection (for electrical accessory
operation)
► Have the following activities performed by
an electrically qualified person (pursuant to
separate instructions):
–
Installation and connection of the elec-
tric set
–
Connection of the heating element to
the electric set
7