Publicité
Les langues disponibles
Les langues disponibles
English
Accepting door calls
The ringing tones for the front
door and apartment door are dif-
ferent. When a visitor presses the
door bell, the telephone rings and
the mute button flashes.
The visitor's image can be seen
on the monitor. Using the zoom
function, an excerpt of the picture
can be enlarged. The call can be
accepted within 45 seconds of the
last ring tone.
Actuating the door release
When you press the door release
button, the door from which the
last call came is opened for 3
seconds.
Switching on the light
When you press the light button,
the lighting is switched on, pro-
vided this has been connected by
your electrical installer.
Muting the bell
When the mute button is pressed
briefly, all the ringing tones are
switched off or on again. The
button lights up red to indicate
that the mute has been activated.
If a visitor rings the door bell while
the in-house telephone is switched
to mute, the button flashes.
Selecting a door station
Lift the receiver. Press the light
button twice to make a speech
connection to the door station
from which the last call came.
Ring tone volume
The ring tone volume can be set to
5 different levels:
Put down the receiver then
press and hold down the mute
button for 3 seconds to hear the
set ring tone volume.
Press the mute button briefly
and the volume increases by one
level. After the highest level it goes
back to the lowest level.
6
Save the selected volume by
pressing the mute button for 3 sec-
onds.
Ring tone melody
You can choose between 11 ring
tone melodies. The ring tone is
always set for the door from which
the last call came.
For this reason, first ring the bell at
the front door or apartment door.
(A different ring tone melody can
also be selected for internal or
group calls).
When the handset is on-hook:
Press and hold down the door
release and light button simultane-
ously for 3 seconds to hear the set
ring tone melody.
Pressing the mute button
changes the ring tone melody.
Save the selected ring tone
melody by pressing the mute
button for 3 seconds.
Button assignment
The telephone buttons can be
used for functions such as setting
up internal calls or for switching
and control functions. All but-
tons can be double assigned (with
the exception of the door release
button). Every button is backlit by
a lamp to indicate its switching
status. For more detailed informa-
tion, please contact your electrical
installer.
Switching on the monitor
Pressing the monitor button will
show the camera picture from the
door which placed the last door
call. This function is only possible if
there is currently no call connected.
Video memory
The bus telephone is equipped
with a video memory. All visitor
pictures are saved with a date
and time. Up to 28 pictures can
Publicité
