HOLZMANN MASCHINEN HOB 260NL Notice D'emploi page 47

 To start the machine push start button (E)
 Insert workpiece so that the surface to be machined facing
upwards and push forward
 The workpiece is pulled through of the automatic feed
 As soon as the half of the workpiece has been processed
change to the opposite operator side of the machine and
take on the finished workpiece
Long workpieces must be supported
Property damage and injury by bouncing up the workpiece or tilting of
the machine possible!




HOLZMANN MASCHINEN GmbH
If the workpiece is no longer moved by the automatic feed, pull out the
workpiece manually
After operation switch off the machine with stop button (F) and set feed
lever (D) to position "OFF"
Before further activities wait until blade shaft is at a standstill!
In order for planing the before described thicknessing procedure must be
reversed
www.holzmann-maschinen.at
A T T E N T I O N
N O T I C E
OPERATION
47
HOB 260NL