Télécharger Imprimer la page

Setting Lower Attachments Points; Installing The Pto Shaft; Hydraulic Connection (Opt) - breviglieri MekFarmer 170 Manuel D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour MekFarmer 170:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

the ground. Insert the attachment pin (1). Lock the pin
with the trigger split pin (2), part of standard equipment.
1
FIG. 25
• Lock the power lift bars with the relative chains and pa-
rallel idlers on the tractor. This must be done to prevent
the machine from swinging sideways
• Start the tractor. Start lifting the machine from the
ground. Turn off the tractor. Remove the keys from the
dashboard.
• Set the arms of the tractor power-lift so that the machi-
ne is levelled. The blades have to be at the same distan-
ce from the ground on both sides of the machine.
5.6.2

SETTING LOWER ATTACHMENTS POINTS

• Remove the spilt pin (1, "Fig. 26").
• Take out the pin (3).
• Take out and rotate at 180°the tractor hitch (2).
• Insert again the hitch into its seat.
• Insert the pin (3).
• Fasten the pin with the spilt pin (1).
The hitch can also be fitted into the hole (4).
4
FIG. 26
5.6.3

INSTALLING THE PTO SHAFT

DANGER
Installing and uninstalling the PTO shaft must always
be done when the tractor is off.
46
2
1
2
3
MekFarmer 170
CAUTION
When hitched to the tractor, the machine can only
be operated with the driveline complete with shields
fixed by their chains. Keep well away from the spinning
driveline.
Prevent the shields from turning by means of the rela-
tive chains and always read the operation and mainte-
nance manual supplied with the driveline
Only used a PTO shaft marked «CE», equipped with
guards and locking chains.
• Fit the driveline into the machine's power take-off and
make sure that it is perfectly locked in the correct po-
sition.
• Fit the driveline into the tractor's power take-off and
make sure that it is perfectly locked in the correct posi-
tion. Make sure that the shield is free to turn.
• Fasten the shield with the relative chain. Remove the
support from the driveline (4 Fig. 1) and fix it on the re-
lative hook.
• Lift and lower the machine to check if the length of the
PTO shaft is correct.
NOTE
IF THE PTO SHAFT IS TOO LONG YOU CAN SHORTEN IT FOL-
LOWING THE INSTRUCTIONS GIVEN IN THE INSTRUCTION
MANUAL OF THE PTO SHAFT.
IF YOU LOSE THE PTO SHAFT INSTRUCTION MANUAL, CONTACT
THE PTO SHAFT MANUFACTURER OR BREVIGLIERI AFTER-SA-
LES SERVICE.
5.6.4

HYDRAULIC CONNECTION (OPT)

There is a hydraulic connection on models with hydraulic
setting of the roller position.
• Maximum pressure: 2610 psi
• Tube diameter: 1/4"
2
1
FIG. 27
A Rear roller lowering.
B Rear roller lifting.
The two cylinders (1, "Fig. 27"), have an automatic release
valve (2"Fig. 27").
1 Roller control cylinders.
2 3/8" gas locking valve.
3 Flow divider valve.
4 Sheath to protect the hydraulic pipes.
3
4
B
A

Publicité

loading