Fitting Hitch For Frontal Use Of The Machine; Fitting Side Shield With Connecting Rod (Opt); Fitting Track Eradicator (Opt) - breviglieri MekFarmer 170 Manuel D'utilisation Et D'entretien

MekFarmer 170
4.2.3 FITTING HITCH FOR FRONTAL USE OF
THE MACHINE
Weight: 463 lb
1
2
4 5
3
FIG. 15
1 Three point hitch pin
2 Tie rod
3 Lower support
4 Pin
5 Lower hitch for power-lift
6 PTO shaft (OPT)
• Place the hitch onto the machine: insert the lower hi-
tches (3, "Fig. 16") onto the plates at the basis of the
three point hitch frame.
• Fasten the lower hitches with the pins (4).
• Connect the tie rod (2) to the machine three-point hitch.
• Fasten the tie-rod with the pin (1).
4
FIG. 16
4.2.4 FITTING SIDE SHIELD WITH
CONNECTING ROD (OPT)
Version
Side shield (STD)
Side shield with connecting rods (OPT) 28
• Remove the side shield fitted onto the machine.
• Loosen the bolts (2, "Fig. 17"). Loosen the nuts (1). Re-
move the unit.
6
Kg lb
25 55
62
1
FIG. 17
• Place the side shield with connecting rods unit into the
holes on the machine.
• Loosen the nuts (1, "Fig. 18").
• Loosen the bolts (2).
The side shield with connecting rods adjust itself
► OPT
automatically according to the soil.
FIG. 18
4.2.5

FITTING TRACK ERADICATOR (OPT)

Fit the track eradicator support (1, "Fig. 19") onto the front
bar. Insert track eradicator (2) between the plates (3).
Adjust height from the ground. Tighten nuts (4).
2
3
4
FIG. 19
2
1
2
1
43