Installing/Removing Elevating Legrest; Installing Elevating Legrest; Removing Elevating Legrest - Invacare Patriot Manuel De L'utilisateur Et D'entretien

SECTION 5—FRONT RIGGINGS
FIGURE 5.3 - REMOVING/INSTALLING HEEL LOOPS

INSTALLING/REMOVING ELEVATING LEGREST

If converting to elevating legrests, pull-to-lock wheel locks MUST be installed to
ensure the wheelchair locks in place - otherwise injury or damage may result.
NOTE: For this procedure, refer to FIGURE 5.4.

INSTALLING ELEVATING LEGREST

1. Insert the footplate assembly into the calfpad assembly and secure it with bolt and nut.
2. Place legrest/calfpad assembly on the outside of the wheelchair and insert legrest
mounting pin into the legrest mounting tube on the wheelchair frame.
3. Rotate legrest/calfpad assembly toward the inside of the wheelchair until it locks in
place.
NOTE: The calfpad of the legrest will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for opposite legrest assembly.
5. Adjust footplate to correct height by
loosening the bolt and nut and sliding
the inner tube up or down until desired
height is achieved. Securely tighten
bolt and nut.
REMOVING ELEVATING
LEGREST
1. Push the legrest release handle inward
while rotating the footrest outward.
2. Lift legrest assembly out of the legrest
mounting tube.
Patriot™
Mounting Screw
Spacer
Locknut
WARNING
Mounting
32
Heel Loop
Mounting Tube
Footplate
Tube
Mounting Pin
FIGURE 5.4 - INSTALLING/

REMOVING ELEVATING LEGREST

Legrest Release
Handle
Legrest Support
Bolt and Nut
Pivot Tube
Footplate
Part No 1088909