Adjusting Elevating Legrest/Calfpad Assembly; Adjusting The Legrest; Adjusting The Calfpad; Installing Adjustable Angle Flip-Up Footplates - Invacare Patriot Manuel De L'utilisateur Et D'entretien

ADJUSTING ELEVATING LEGREST/CALFPAD
ASSEMBLY
NOTE: For this procedure, refer to FIGURE 5.5.

ADJUSTING THE LEGREST

1. Raise legs until the desired height is obtained by lifting up on the footplate assembly.
2. To reposition legrest to normal position, support leg with one (1) hand and push
release lever forward with other hand.

ADJUSTING THE CALFPAD

1. Turn the calfpad towards the outside of wheelchair.
2. Slide the calfpad up or down until the desired position is obtained.
3. To secure the calfpad, turn the calfpad towards the inside of the wheelchair.
Release Lever
FIGURE 5.5 - ADJUSTING ELEVATING LEGREST/CALFPAD ASSEMBLY
INSTALLING ADJUSTABLE ANGLE FLIP-UP
FOOTPLATES
NOTE: For this procedure, refer to FIGURE 5.6.
NOTE: This procedure is for individual adjustable angle footrests only.
1. Position the adjustable angle flip-up footplate hinge on the footrest support tube at the
desired height.
2. Position the hardware on the footrest support as shown in FIGURE 5.6.
3. Flip the footplate hinge to the "up" position.
NOTE: The footplate hinge will fall to the "down" position.
4. Tighten the socket screw and locknut that secure the footplate hinge to the footrest
support until the footplate hinge remains in the up position.
Part No 1088909
SECTION 5—FRONT RIGGINGS
Calf Pad Rotated For
Height Adjustment
33
Calf Pad
Patriot™