Technical Data; Battery Tester - Würth 1 A/4 A Traduction Du Mode D'emploi D'origine

Prod. no.
Nominal voltage
Charging current
Battery capacity
Battery type
Output power
Input voltage
Ripple current
Degree of protection IP65
Weight
Device elements (fig. I)
Overview
1 Selector
2 Button for LED light
3 Battery charging state
4 Malfunction indicators
5 Charging modes
6 Crocodile clips
7 Motorcycle charging cord
8 Cigarette lighter cord (item no. 0772 4)
9 Battery temperature sensor (item no. 0772 30 15)
10 Supply cord
Setting up (fig. II)
The device can be used as
As stationary device [11]
■
As handheld device [12]
■
As suspended device [13]
■
As device on the wall [14]
■
12

Technical data

0772 4
12 V
1 A / 4 A
3 Ah - 80 Ah
WET/GEL/AGM
75 W
230 V ± 10 %
50 Hz ± 3 Hz
3 %
0.490 kg
0772 15
12 V
15 A
40 Ah - 300 Ah
WET/GEL/AGM
275 W
230 V ± 10 %
50 Hz ± 3 Hz
4 %
IP44
0.900 kg
Battery charging (fig. III)

Battery tester

Note
The battery tester can only be put
in operation if the power supply is
switched off.
Connect the terminals with the vehicle battery
■
(red terminal with "+" and black terminal with
"-") to determine the charging state of the battery
with the battery tester, which will be shown on
the display.
The battery must be at ambient temperature
■
(20°C) and at least 4 hours in resting state
(without charging any vehicle or intelligent bat-
tery care) to ensure that the displayed value is
reliable.
If a battery was charged within the last 4 hours,
the displayed value will be higher. Before a
battery is charged, it is always tested to ensure
optimum charging conditions for the intelligent
battery care system.
0772 30 15
12/24 V
30 A / 15 A
90 Ah - 600 Ah
WET/GEL/AGM
525 W
230 V ± 10 %
50 Hz ± 3 Hz
4 %
IP44
1.360 kg