Westfalia 320 040 Notice De Montage Et D'utilisation page 14

Table des Matières

Les langues disponibles

3.)

Insert U profiles 3 and 4 on left and right into frame side member of vehicle, ensuring that fixing points 'b'

and 'c' are aligned.

Beforehand, with the Coupé, a spacer shim 14 must be fitted in the right and left frame side members

and aligned with fixing point 'c'. Loosely fit brackets 2 on vehicle on left and right at 'a' from front on rear

apron using hexagon bolts M10x30, washers 10.5x30x3 and hexagon nuts M10.

4.)

Hold towing bracket basic component 1 under vehicle and loosely secure at 'b' using hexagon bolts

M12x50 and washers 12.5x30x3 and at 'c' using hexagon bolts M10x50 and washers 10.5x30x3.

Align towing bracket and tighten hexagon bolts at 'b' and 'c'. Bracket 2 must contact rear apron at 'a'.

Then tighten bolts at 'a'.

Tightening torque:

5.)

Secure exhaust pipe bracket at 'd' using hexagon bolts M8x30 and washers 8.5x21x2.

Tightening torque:

6.)

Detach removable towbar and insert plug in mounting pipe.

Lash towbar at front on spare wheel with tightening strap provided.

7.)

Install electrical set (see installation instructions for electrical set).

Refit removed components on vehicle. To install the bumper, if necessary use the blind rivets provided.

Tightening torque of wheel nuts

at 'b'

for M12

at 'a', 'c'

for M10

at 'd'

for M8

110 Nm

65 Nm

40 Nm

20 Nm

Subject to alteration.

Table des Matières