Maintenance - Habegger HIT-TRAC 16 B Mode D'emploi

The load can not be Brake is wet
lowered
7

Maintenance

The following control and maintenance work has to be carried out:
Work
General visual inspection:
- Driving system
- Housing
- Anchor bolt, pulling lug
Checking screws
Drive belt inspection
Cleaning driving wheel
Gasoline motor: Refill fuel
Relubrication of gear ring
Rope: Visual inspection
- Pressed sleeve
- Eyelet hook with safety
device
Rope: Cleaning
Rope: Checking diameter
Oil level in inspection
glass
The machine, rope and accessories have to be checked at least
every 2 years (see label on the cover) by the manufacturer or an
authorized site. During this inspection, all parts are checked for
deformation, wear and tears.
When When Comments
you start necessar
working y
X
After initial operation or
Inspection
X
X X
X See STIHL operating instruction
X Gear grease
Check for deformation, damage,
tears or broken wires
X
X
For worn ropes, when rope diameter
is < 10 mm or < 7.4 mm:
Replace the rope!
X
Send to Habegger to be
repaired
67