Load - Habegger HIT-TRAC 16 B Mode D'emploi

І
Damage to the rope:
Do not use pinched(1), twisted, flattened or kinked ropes(2), ropes
with twisted(3) or broken strands.
Ropes with protruding wires:
Remove protruding wires.
Damage at the beginning or end of the rope:
If possible, shorten the rope.
Replace the rope when it is worn by more than 10% of the nominal
diameter at its thinnest point
Do not run rope joinings, sleeves, pressure heads, short splices etc. through the drive
system.
When the rope has to be guided over sharp edges, obstacles, etc., protect the rope by
means of adequate ground rollers or pads of wood or plastic.
The rope has to be laid out in an expert manner, i.e. it has to be unwound from the reel in
such a way that no loops are formed, no strands are broken, and the rope is not twisted.
The free end of the rope is marked by colour.
▲
Danger! As soon as the coloured end reaches the
machine during lowering operations: Stop the machine.
3.3.4

Load

The load has to be fastened to the tow hook by means of appropriate fastening devices.
These prevent the load from slipping or tipping over while it is being pulled.
Appropriate fastening devices are, for example, hooks, slings, straps, and belts.
The inherent stability of the load must be ensured to prevent it from slipping off or tipping in
any case while it is pulled.
1
3
2
57