Malfunctions - Habegger HIT-TRAC 16 B Mode D'emploi

6

Malfunctions

Malfunction Possible cause
Motor cannot be
Not enough gasoline
started
Lever on the motor is set to Stop
Other causes
Motor "dies" when Altitude too high as of about 2200
starting m above see level
Carburettor adjusted poorly
The drive system does Tension of the rope is greater than
not move even though the permissible pulling force
the running motor is
Chain brake is not released
accelerated
(blocked)
Drive belt faulty
Centrifugal clutch of the motor is
worn out
Sliding clutch is worn
Sliding clutch is not adjusted
correctly
Cams of the driving plate are
broken
Cams of the crank handle are
broken
Rope does not move Rope inserted wrongly
despite rotating driving
wheel
Wrong diameter of rope
Rope is worn down
Driving wheel or rope greased too
much
Groove in driving wheel is
contaminated
No load is on rope
66
Remedy
Refill fuel
Set lever to Start
See STIHL operating
instruction
Adjust carburettor, reduce
load, or use rope pulleys
Adjust carburettor, see
STIHL operating instruction
Reduce load or use rope
guide pulley system
Release chain brake
Replace drive belt
Replace centrifugal clutch
Reset the sliding clutch
Get the sliding adjusted
Replace driving plate type
07510
Replace handle type 07190
Insert rope according to the
diagram
Insert the correct rope
Insert a new rope
Clean
Clean
Place load on the rope