Scope Of Supply; Use According To Intended Purpose; Residual Risks - Mafell FM 800 Traduction De La Notice D'emploi Originale

2.4.1 Noise emission specifications
Noise emission values determined according to DIN EN ISO 3744:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
The noise measurement was done without tool at idling speed.

2.5 Scope of supply

Operating manual
Open-ended spanner AF 17
Open-ended spanner AF 25
Collet OZ ø / mm
Collet ER 16
Cable / m
Covering cap Z

2.6 Use according to intended purpose

- The milling motor is intended for permanent installation in guiding portal systems with ø 43 mm clamping
collar.
- The milling motor with quick tool clamping can be flanged directly to a portal system using six screws (M6
thread) according to the specifications of the portal system (Fig. 5).
- The milling motor is not designed for continuous industrial operation.
- The milling motor is considered an incomplete machine. The milling motor may only be commissioned once
it has been determined that the portal system into which the milling motor is to be incorporated complies
with the provisions of the current and valid Machinery Directive. Please also note the corresponding
warranty conditions for the milling motor and any supplementary appliances.

2.7 Residual risks

x x
x x
- -
6 8
- -
1 4
- -
Danger
Even if used in accordance with its intended purpose and despite conforming with the
safety instructions, residual risks caused by the intended use that can lead to health
consequences will always remain.
L = 71 dB (A)
PA
K = 3 dB (A)
PA
L = 82 dB (A)
PA
K = 3 dB (A)
PA
x x
x -
- x
8 -
- 8
0.75 + 4 0.75 + 4
x x
-24-
x x
- -
- -
- -
- -
4 0.75 + 4
- x