Setting / Adjustment; Mains Connection; Selection Of Tools; Tool Change - Mafell FM 800 Traduction De La Notice D'emploi Originale

Instructions on service and maintenance:
- Regular cleaning of the milling motor is an important safety factor.
- Only original MAFELL spare parts and accessories may be used. Otherwise, the manufacturer will not
accept any warranty claims and cannot be held liable.
4

Setting / Adjustment

4.1 Mains connection

Prior to initial operation, make sure that the mains voltage agrees with the operating voltage stated on the
milling motor's rating plate.

4.2 Selection of tools

Only use the collets/adapter sleeves listed in the chapter "Optional accessories". Tools are selected depending
on the materials to be processed and the capacity of the feed drives. Please take into account the milling motor
capacity at maximum tool diameter and anticipated machining depth.

4.3 Tool change

4.3.1 Tool clamping by means of collet
The spindle 1 (Fig. 1) of the milling and grinding motor is equipped with a precision collet 2 (Fig. 1) to hold the
tools. The spindle lock is triggered by the locking button 4 and facilitates tightening and loosening of the union
nut 3 (Fig. 1).
Proceed as follows for the tool change:
- Lock the spindle 1 (Fig. 1) to unclamp the tool by pressing the locking button 4 (Fig. 1).
- Detach the union nut 3 with an open-ended spanner AF 17 or wrench ER 16 M.
- Pull off the tool to the front.
- Push the new tool into the tool holding fixture up to the limit stop.
- Check the tool's seat.
- Spindle 1 (Fig. 1) is locked when the tool is clamped.
- The union nut 3 is tightened with the open-ended spanner AF 17 / wrench ER 16 M.
4.3.2 Quick tool clamping
The spindle 7 (Fig. 3) of the quick tool clamping device is equipped with a precision holding fixture for a tool
shank Ø 8.
Proceed as follows for the tool change:
Danger
Pull the power plug during all service work.
Wear protective gloves during a tool change. The insertion tool can get very hot
during longer operation and/or the insertion tool's cutting edges are sharp.
Switch on the milling motor only when the lever 6 (Fig. 3) is not in the tool
➢
change position.
➢ Do not actuate lever 6 (Fig. 3) until the milling motor is at a standstill.
-26-