Function G3 "Program Setback - Sygonix TX 4 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Note:
Incorrect programming of times is automatically prevent-
ed so that the switching processes are not confused.
If you have, e.g., set a temperature of 20.0 °C from 06:00
onwards in memory slot "P1" and a temperature of 18.0 °C
from 09:00 onwards in memory slot "P2", the memory slot
"P3" cannot be programmed to any time before 09:10.
c) Function G3 "PROGRAM SETBACK"
If you want to change the temperature value of all programmes,
e.g., by 1 °C, you do not need to change the entire programming.
You only need to set a correction value (-3.0 °C......+3.0 °C) in
the function G3 "PROGRAM SETBACK".
If you then check your temperatures in function G2 "PROGRAM
SETTING", the value corrected accordingly is displayed there.
Example:
In programme "P1", the time set is 06:00 and the temperature
value is 20.0 °C.
After programming "-1.0 °C" in the function "PROGRAM SETBACK",
the temperature value in programme "P1" is now 19.0 °C.
If you set "0.0 °C" again in the function "PROGRAM SETBACK", the
programme "P1" sets a temperature of 20.0 °C again.
Proceed as follows:
1.
After selecting this function G3 "PROGRAM SETBACK" and
confi rming with "OK" (2), the temperature correction value
fl ashes in the display.
2. Set the correction value (-3.0 °C......+3.0 °C).with the buttons
"–" (5) and "+" (6).
3. Confi rm the setting with "OK" (2).
The room thermostat is then in the previous menu for selec-
tion of functions again.
4. To leave the menu and return to the regular display, push the
button "MENU" (3), repeatedly if required.
63

Publicité

Table des Matières
loading

Table des Matières