Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
-For transport of the machine, secure the mounting arm
against moving out of place.
-Move the clamping jaws into middle position.
-Select the length of the lifting cables such that the angle
of inclination does not exceed 60 degrees, as otherwise
lifting capacity is not sufficient.
-Position the lifting cables or other suitable lifting facilities
on the machine as illustrated in Fig. 2.0.1.
-When lifting the machine, make sure that the lifting cables
are properly positioned (mind the centre of gravity of the
machine) and that the machine does not turn over.
°
2.2 Installation Area
Install the machine in a covered and dry place. Operation
temperature is +41/+122 F (+5/50 C).
A. Remove the screws that attach the machine to the
pallet.
B. Assemble the adjustment knob (#3 Fig. 2.1) to the
tower.
C. Bolt the column (Fig.2.2) and screw it to the cabinet
with the four screws #1, washers #2 and nuts #3.
Screws must be firmly tightened.
2.1
2.1
2.1
2.1
2.1
D. Place the bead breaker arm #1 (Fig.2.3) inside arm
support #4. Holes #5 for the arm and arm support must
match. Grease pin #6. Lock arm #1 to support #4 with pin
#6 and
self locking hub nut
#7.
2.2
2.2
2.2
2.2
2.2
E. Attach spring #3 (Fig.2.3) to the hook #2 on bead
breaker arm and attach it to the pin on the frame. Then
drive the pin down.
2.3
2.3
2.3
2.3
2.3
F. Secure the machine to the floor through the holes
provided in the cabinet. Secure the machine to the ground
with anchor bolts 3/8x2" (Recommended).
2.3 Electrical Installation
WARNING!
ALL ELECTRICAL CONNECTIONS SHALL BE
PERFORMED BY A LICENCED TECHNICIAN.
ALL SERVICE MUST BE PERFORMED BY AN
AUTHORIZED SERVICE TECHNICIAN.
Check that the electrical specifications of the power source
are the same as the machine. The machine uses 115VAC,
1Hp, 12Amp.
287
Electric specifications are clearly marked on a label at the
end of the electric cord.
WARNING!
FAILURE TO PROVIDE PROPER ELECTRICAL SUPPLY
AND GROUNDING WILL CREATE A SHOCK HAZARD TO
THE OPERATOR.
1066
961
7
Publicité
Table des Matières
