Changing The Factory Setting Of A Function Button - Sony HT-K170 Mode D'emploi

Changing the Factory Setting
of a FUNCTION Button
If the factory settings of the SYSTEM CONTROL/
FUNCTION buttons ("Using the remote" on page 12)
don't match your system components, you can change
them. The following table shows the possibility of
alternate function assignment for each button.
Button Possible assignment
VIDEO VTR 1, VTR 2, VTR 3
DVD DVD, LDP, CD
* Initial setting of VIDEO is VTR 3.
* Sony VCRs are operated with a VTR 1, 2, or 3 setting that
corresponds to Beta, 8mm, and VHS, respectively.
Resetting key table for function key VIDEO
VTR 1 CURSOR UP
VTR 2 ENTER/EXECUTE
VTR 3 CURSOR DOWN
Resetting key table for function key DVD
DVD EXIT/RETURN
LD DISPLAY
CD CURSOR RIGHT
Amplifier Operations
MENU
control keys
For example, if you connect a Sony LD player to the
DVD jacks, you can assign the DVD button to set the
remote to control the LD player.
1
Hold down the SYSTEM CONTROL/FUNCTION
button whose function you want to change (DVD,
for example).
2
Press the corresponding button of the component
you want to assign to the SYSTEM CONTROL/
FUNCTION button (DISPLAY, LD player, for
example).
Now you can use the DVD button to control your
Sony LD player.
To reset a button to its factory setting
Repeat the above procedure.
To reset all the function buttons to their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at the same time.
SYSTEM
CONTROL/
FUNCTION
13 GB