Getting The Most Out Of Dolby Pro Logic Surround Sound - Sony HT-K170 Mode D'emploi

Using Surround Sound
Getting the Most Out of Dolby
Pro Logic Surround Sound
To obtain the best possible Dolby Pro Logic Surround
sound, first select the center mode according to the
speaker system you have. Then, adjust the volume of
each speaker.
Note that you must connect the rear speakers and/or
one center speaker to do the following adjustments.
Center mode
indicators
CENTER MODE
SOUND FIELD
ON/OFF
TEST TONE
REAR
LEVEL +/–
16 GB
Sound field
Display indicators
SOUND FIELD
SOUND FIELD
MODE
EFFECT/
DELAY –/+
CENTER
LEVEL +/–
Selecting the center mode
The amplifier offers you four center modes: Phantom,
Wide, Normal and 3 Stereo. Each mode is designed for
a different speaker configuration.
1
Press SOUND FIELD repeatedly to select the PRO
LOGIC sound field.
2
Press CENTER MODE repeatedly until the
indicator for the center mode you want lights in
the display. Select the center mode as follows:
If you have Select
Front and rear PHANTOM
speakers, no
center speaker
Front and rear WIDE
speakers, and
a large center
speaker
NORMAL
Front and rear
speakers, and
a small center
speaker
Front and center 3 STEREO
speakers, no rear (3 Channel Logic)
speaker
Notes
• To match the speaker system that is packed together with
this amplifier, we recommend that you set the center
mode to NORMAL or WIDE and turn on the subwoofer.
• If you are using a different speaker system, select the
mode that best suits your speaker system's configuration.
So that
The sound of the
center channel is
output from the front
speakers.
The center channel
fully reproduces the
entire audio spectrum
The bass sound of the
center channel is
output from the front
speakers.
The sound of the rear
channel is output
from the front
speakers.