Zanussi ZDT15006FA Notice D'utilisation page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Alarm code
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 1 time intermittently.
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 2 times intermittently.
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 3 times intermittently.
Warning! Deactivate the appliance before
you do the checks.
Problem
The programme does not
start.
The appliance does not fill
with water.
The appliance does not
drain the water.
After the checks are completed, activate the ap-
pliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.
If other alarm codes show, contact the Service.
12
Possible cause
The mains plug is not connected in
the mains socket.
The appliance door is open.
The fuse in the fuse box is damaged.
The delay start is set.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or there is
limescale on it.
The filter in the water inlet hose is
clogged.
The water inlet hose has a kink or a
bend.
The anti-flood device is on. There are
water leakages in the appliance.
The sink spigot is clogged.
The water drain hose has a kink or a
bend.
Problem
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
Connect the mains plug.
Close the appliance door.
Replace the fuse.
Cancel the delay start or wait for the
end of the countdown.
Open the water tap.
Contact your local water authority.
Clean the water tap.
Clean the filter.
Make sure that the position of the
hose is correct.
Close the water tap and contact the
Service.
Clean the sink spigot.
Make sure that the position of the
hose is correct.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a lower
position.
Possible solution
www.zanussi.com

Publicité

Chapitres

Table des Matières
loading

Table des Matières