Care And Cleaning; Troubleshooting - Zanussi ZDT15006FA Notice D'utilisation

Care and cleaning

Warning! Before maintenance, deactivate
the appliance and disconnect the mains
plug from the mains socket.
Dirty filters and clogged spray arms de-
crease the washing results.
Make a check regularly and, if necessary, clean
them.
Cleaning the filters
1
3
To remove filters (B)
and (C), turn the han-
dle counterclockwise
and remove. Pull
apart filter (B) and
(C). Wash the filters
with water.

Troubleshooting

The appliance does not start or it stops during
operation.
Before you contact the Service, refer to the in-
formation that follows for a solution to the prob-
lem.
www.zanussi.com
C
B
A
2
A
4
Remove filter (A).
Wash the filter with
water.
D
A
5
Put filter (A) to its ini-
tial position. Make
sure that it assembles
correctly under the
two guides (D).
An incorrect position of the filters can
cause bad washing results and damage to
the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin pointed
object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
Internal cleaning
If you regularly use short duration programmes,
these can leave deposits of grease and lime-
scale inside the appliance.
To prevent this, we recommend to run long du-
ration programmes at least 2 times per month.
With some problems, different indicators
flash continuously or intermittently at the
same time to show an alarm code.
6
Assemble filters (B)
and (C). Put them into
position in filter (A).
Turn the handle
clockwise until it
locks.
11