Stopping The Engine - Matrix F1 2500 Traduction De La Notice Originale

6.4 When the generator is used to supply
power to two or more devices mentioned
above, connec t or turn on the devices
one after another. First switch on high-
per formance devices with high current
consumption or high starting current, and
then the devices at lower performance. (B14)
6.5 Connect as follows
WARNING:
All cable connections of the generator to the
domestic mains supply shall only be done by
qualified electricians. Improper connections
will damage the generator, or even cause a
fire hazard.
8. MAINTENANCE
The following table describes the maintenance intervals required and the type of
maintenance to be executed.
INTERVALLES
OBJET
Check engine oil
Change engine oil
Oilpan cup
Filter of oilpan cup
Ignition plug
Tappet clearance
Clean piston housing
Clean fuel tanke
40
or after 20 hours
for initial
operation
check
change
check
6.6 Please carefully read these instructions,
before the generator supplies power
6.6.1 Start generator. (B15)
6.6.2 Connect electrical consumer loads (B16)
6.6.3 Turn on AC protective switch. (B17)

7. STOPPING THE ENGINE

7.1 Turn off AC protective switch. (B18)
7.2 Set the switch to OFF. (B19)
7.3 Turn the fuel cock to OFF. (B20)
NOTE: Set the switch to OFF to stop the
generator in case of emergency
or every three
months
clean
Replace every three years
or every six
or every year
months
change
clean
clean
clean
Check and
readjust
clean