Sprayer Controls - WAGNER FLEXIO Série Manuel De L'utilisateur

SPRAYER CONTROLS

For a video showing FLEXiO spraying tips and best practices, visit:
i
www.wagnerspraytech.com/flexio
X-BOOST™ POWER SWITCH
The X-Boost™ power switch adjusts the level of air
i
pressure produced by the turbine. The X-Boost™
power dial is factory-set at maximum out of the
box.
2-Speed Air Power Control - The FLEXiO Handheld Sprayer is
equipped with a 2-speed air power control (high / low).
•
A high air power level (II) will result in faster coverage and a
smoother finish with thicker materials.
•
Lowering the air power (I) will result in larger drops of material
being sprayed from the gun, and will create a slightly rougher
finish.
Tip: The thicker the material you are spraying, the higher the
turbine power you will need.
Tip: For fine-finish work with thinner materials, you may want
to decrease the air power. Spraying a thinner material at high air
power will result in more overspray. Overspray is sprayed material
that does not stick to the spray surface and bounces back.
MATERIAL FLOW CONTROL
The material flow control will be factory-set at its
i
lowest setting out of the box. Adjust as needed.
•
Turn the knob out (counterclockwise) for less flow. Generally,
low material flow is needed for spraying smaller surface areas,
such as corners, lattice, or spindles.
•
Turn the knob in (clockwise) for increased flow. Generally,
high material flow is needed for spraying large surface areas,
such as fences and decks.
8
iSPRAY
EN
DETAIL FINISH
(included in some
models)