WAGNER FLEXIO Série Manuel De L'utilisateur page 5

CONTROLS AND FUNCTIONS
iSPRAY
WIDE
iSPRAY
=
= =
=
=
=
ON / OFF SWITCH
The ON/ OFF switch turns the turbine ON (I) and OFF (0).
No spray material will be delivered until trigger is pulled.
MATERIAL FLOW CONTROL
DETAIL FINISH
The material flow control determines the amount of spray
material that is sprayed from the spray nozzle.
iSpray Nozzle - The material flow can be adjusted
incrementally from 1 (minimum) to 12 (maximum) by
turning the adjustable material flow control.
Detail Finish Nozzle (if included) - Set the material flow by
turning the red knob on the trigger of the spray gun.
TRIGGER
Pulling the trigger will deliver material from the material
container to the nozzle assembly, where it is sprayed.
NARROW
SPRAY WIDTH LEVER (iSPRAY NOZZLE ONLY)
The spray width lever determines the width of the spray
pattern.
DETAIL FINISH*
ADJUSTMENT RING
The spray pattern shape is adjusted by turning the
adjustment ring to either the vertical, horizontal or
diagonal* positions.
=
Horizontal pattern (use 'up and down' spraying motion)
=
=
=
Vertical pattern (use 'side to side' spraying motion)
*Round pattern - Detail Finish nozzle only, if included
= =
(Use 'up and down' or 'side to side' spraying motion)
EN
5