Troubleshooting - WAGNER FLEXIO Série Manuel De L'utilisateur

TROUBLESHOOTING

PROBLEM
Problem A: Little or no material flow
Problem B: Material leaking
Problem C: Spray pattern too thick, runs
and sags
Problem D: Spray jet pulsates
Problem E: Too much overspray
Problem F: Pattern is very light and
splotchy
i *Only thin the material as a last resort to improve spray performance.
Optimal spray performance should be acheived simply by adjusting the
various controls on the unit.
This unit contains no servicable electrical parts. Do not attempt to
service yourself. Store indoors with the cord wrapped around the
turbine handle.
Have you tried the recommendations above and are still having
problems? In the United States, to speak to a customer service
representative, call our Technical Service at 1-800-328-8251. See www.
wagnerspraytech.com in the "Contact Us" section for Technical Service
hours.
CAUSE
1. Nozzle clogged.
2. Suction tube clogged.
3. Material flow setting too low.
4. Suction tube loose.
5. No pressure build up in container.
6. Air filter clogged.
7. Spray material too thick.
8. Nozzle seal missing or worn.
1. Nozzle loose.
2. Nozzle worn.
3. Nozzle seal missing or worn.
4. Material build-up on air cap and nozzle
1. Material flow setting too high.
2. Air power setting too low.
3. Applying too much material.
4. Nozzle clogged.
5. Air filter clogged.
6. Too little pressure build-up in container.
7. Spray material too thick.
1. Material in container running out.
2. Air filter clogged.
1. Gun too far from spray object.
1. Moving the spray gun too fast.
2. Material flow setting too low.
3. Air power setting too high.
EN
SOLUTION
1. Clean.
2. Clean.
3. Increase material flow setting.
4. Remove and replace as tightly as possible.
5. Tighten container. Check the air vent hole
on the pick up tube - clean if clogged.
6. Change
7. Thin*.
8. Replace nozzle.
1. Tighten.
2. Replace.
3. Replace nozzle.
4. Clean.
1. Decrease material flow setting.
2. Increase air power setting.
3. Adjust material flow or increase
movement of spray gun.
4. Clean.
5. Change.
6. Tighten container.
7. Thin*.
1. Refill.
2. Change.
1. Reduce distance (6"-8" is ideal).
1. Adjust material flow or decrease
movement of spray gun.
2. Increase material flow setting.
3. Decrease air power setting.
QUESTIONS?
Call Wagner Technical Service at:
1-800-328-8251
Register your product online at:
www.wagnerspraytech.com
13