Functional Description; Tools Needed - Matrix JF72553B Traduction De La Notice Originale

5. Blade guard assembly
6. Blade wrenches
7. Anti-Kickback Device
8. Table insert
9. Push stick
10. Long top plates
11. Short top plates
12. Long support plates
13. Short support plates
14. Legs
15. Rubber feet
16. Hardware kit (not shown)
ASSEMBLY TIME
The expected time to assemble and properly
adjust this saw is two hours.

FUNCTIONAL DESCRIPTION

A Overload Reset button
B On/Off paddle switch
C Saw blade
D Blade elevation handwheel
E Sawdust port
F Rip fence scale
G Mitre gauge lock knob
H Mitre gauge
I Table
J Blade guard
K Anti-kickback pawls & splitter
L Kerf plate
M Mitre gauge storage
N Base
O Fence lock handle
P Blade tilt scale
Q Stand
R Rip fence
ASSEMBLY
WARNING: RISK OF PERSONAL INJURY. Always
disconnect tool from power source before
making any adjustments, installing or changing
accessories.
CAUTION: The tool must be assembled before
use. DO NOT plug unit into power source until
the unit has been completely assembled and all
guards are in place.

TOOLS NEEDED

The following tools are needed for assembly (not
included):
Adjustable crescent wrench
Phillips screwdriver
Combination square
5 mm Allen wrench
TO ASSEMBLE THE LEG STAND
See Figure 3.
WARNING: After completing adjustments,
securely tighten all fasteners. An
unstable stand may shift in use and cause serious
personal injury.
WARNING: The stamped rails may have sharp
edges. Be careful in handling the rails to prevent
being cut.
NOTE: Use the screws 1, washers 2, and lock nuts
3 supplied in the hardware kit
to attach the pieces of the leg stand together (Fig.
25). Do not tighten the
hardware completely until the leg stand is
completely assembled.
The following letters are stamped on pieces for
identification:
A - Legs (qty. 4).
B - Front and rear top plates (qty. 2).
C - Side top plates (qty. 2).
D - Side support plates (qty. 2).
E - Front and rear support plates (qty. 2).
1. Attach the side top plates C to the legs A.
2. Attach the side support plates D to the legs A.
3. Place the front and rear top plates B over the
side top plates C. and attach to the legs A.
4. Attach the front and rear support plates E to
the legs A.
5. Tap the four rubber feet 4 onto the bottom of
the legs A.
13