Operating Procedures - Matrix JF72553B Traduction De La Notice Originale

MOUNTING THE TABLE SAW ON THE STAND
See Figure 4.
Do not lift the saw without help. The saw base
weighs ap proximately 42 lbs.
Hold it close to your body. Keep your knees bent
and lift with your legs, not your back. Ignoring
these precautions can result in back injury.
∙ Take the following from a small hardware pack:
4 carriage bolts (M8X60)
4 hex nuts (M8)
NOTE: This hardware was in the pack with
hardware for assembling the leg stand and
leveling feet.
∙ Place the saw base on the leg stand. Align
the holes in the table with the holes in the end
braces.
∙ Place a bolt in each hole. Secure with a hex nut.
Hand tighten.
∙ Repeat for three remaining holes. Tighten all
hardware securely.
HANDWHEEL ASSEMBLY
1. (see fig.5) Assemble handwheel (U) to shaft (X)
making sure the flat on inside of handwheel lines
up with flat on shaft.
2. (see fig.6) Fasten handwheel (U) to shaft using
a M6 x 12 mm flat head Phillips screw (Y).
ATTACHING THE SMART GUARD SYSTEM
POSITIONING THE RIVING KNIFE
1. Remove table insert using finger hole.
2. Raise the blade as high as it will go and set it
perpendicular to table (0° on bevel scale) (Fig. 7).
3. Rotate the riving knife release lever 1 clockwise,
so that it points upward (Fig. 7).
4. Pull riving knife 2 towards release lever to
disengage it from the pins 3.
5. Slide the riving knife 2 up to its highest
position, so that it is directly over
the center of the blade (Fig. 8).
6. Align holes in riving knife with pins 3 and lock
the release lever 1 by rotating it counterclockwise.
Push/pull riving knife to verify that it is locked
in place (Fig. 8).
7. Replace table insert (Fig. 9).
ATTACHING THE BLADE GUARD ASSEMBLY
8. With one hand, hold the front of the blade
guard assembly 4 by the metal
"fork". With the other hand, hold the guard
release lever 5 up (Fig. 9).
9. Lower the rear of guard assembly and slip the
cross bar 6 into the rear
notch 7 on top of the riving knife 2 (Fig. 9).
10. Lower the front of the guard assembly 4 until
the metal "fork" is parallel
with the table (Fig.10).
11. Press down on the guard release lever 5 until
you feel and hear it snap
into the locking position. Check that the guard
assembly is securely
connected (Fig. 10).
ATTACHING THE ANTI-KICKBACK DEVICE
12. While pulling out the attachment pin 8, attach
the Anti-Kickback Device 9
into the flat recessed area 10 of the riving knife 2
(Fig. 11).
13. Slide the Anti-Kickback Device down until it
drops into the recessed area
– then release the attachment pin such that the
Anti-Kickback Device locks onto the riving knife
immediately behind the guard assembly.
Check that the attachment pin is securely
connected into locking hole.
14. Carefully raise and lower the pawls 11 – when
letting go, the spring-loaded pawls must come
down and contact the table insert (Fig. 11).
Note: The two attachments are independent of
each other, so the Anti-Kickback Device can be
attached before the Blade Guard Assembly.

OPERATING PROCEDURES

WARNING: DO NOT OPERATE saw until it has
been assembled and installed according to the
instructions in "ASSEMBLY". Read and follow all
safety rules within this Instruction Manual, failure
to do may result in electric shock and/or
serious personal injury.
14