Matrix JF72553B Traduction De La Notice Originale page 9

the switch is in the OFF position before plugging
in.
∙ DISCONNNECT THE PLUG FROM POWER
BEFORE MAKING ANY ADJUSTMENTS.
Changing attachments or accessories can be
dangerous if the tool could accidentally start.
∙ DO NOT USE THE TOOL IF IT CANNOT BE
SWITCHED ON OR OFF. Have
your tool repaired before using it.
∙ STAY ALERT. Watch what you are doing & use
common sense. Don't operate
any tool when you are tired, or under the
influence of alcohol, drugs or medications
that cause drowsiness.
∙ CHECK FOR DAMAGED PARTS. Before using
this tool, any part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function.
Check for alignment of moving parts, binding
of moving parts, breakage of parts, mountings,
and other conditions that may affect its
operation. Inspect screws and tighten any ones
that are loose. Any part that is damaged should
be properly repaired or replaced by an authorized
service center unless otherwise indicated
elsewhere in the instruction manual.
Have defective switches replaced by an
authorized service center. Don't use the
tool if switch does not turn it on and off properly.
∙ REPLACEMENT PARTS. When servicing, use
only identical replacement parts.
∙ SERVICE AND REPAIRS should be made by
qualified repair technicians at an
authorized repair centre. Improperly repaired
tools could cause serious shock or
injury.
SPECIFIC SAFETY INSTRUCTIONS FOR
TABLE SAWS
1. DO NOT OPERATE table saw until it has
been assembled and installed according to the
"assembly" instructions of this manual.
2. KEEP THE SAW TABLE free of tool and debris.
3. USE AN AUXILIARY WORK SUPPORT when
sawing long or wide work pieces to assure firm
control of the work piece at all times.
4. USE THE BLADE GUARD, spreader and anti-
kickback device whenever possible. Use the
guard on all operations where the saw blade cuts
through the thickness of the work piece.
5. THE BLADE SHOULD PROJECT ONLY A
MINIMAL DISTANCE ABOVE THE CUT: 1/8" to
1/4" (3-6 mm) for most operations.
6. NEVER REACH over or behind the blade with
the table saw operating.
7. WHEN USING THE TABLE SAW for dadoing,
grooving or shaping, use a push
block to keep your ands and fingers well away
from the saw blade in case of
kickback or other unexpected event.
8. CHECK OFTEN to assure that guards return to
their normal position quickly. If
a guard seems slow to return or "hangs up, " repair
or adjust it immediately.
9. DO NOT CUT FREEHAND (cutting without the
use of a mitre gauge or rip fence).
10. WHEN CROSSCUTTING, use the mitre gauge
to assure a straight cut, not the
rip fence. The cut off piece can bind between the
fence and blade, causing
kickback and possible injury.
11. WHEN RIPPING, always use the rip fence to
9