Featherboard; Product Specifications; Unpacking And Checking Contents - Matrix JF72553B Traduction De La Notice Originale

CROSS CUT
A cut made across the grain of a board.

FEATHERBOARD

Pieces of wood with fingers used to hold material
against a fence and or down against the table on
power tools.
FENCE
A straight guide on a tool such as a table saw,
band saw or router table to keep the material a
set parallel distance from the blade or cutter.
FREE HAND
Performing a cut without the workpiece in
contact with and supported by the work table,
fence, or mitre gauge.
KERF
The slot or groove made by the saw blade during
a cut, usually concerning its width.
MITRE CUT
A cross cut made with the workpiece at any angle
to the blade other than 90.
MITRE GAUGE
A guide with an adjustable head that fits in a slot
and slides across a power tool
table to hold material at an angle.
PUSH STICK
A hand-held safety device used for pushing wood
past a cutter to keep the hands
away from the blade.
RIP CUT
A cut which runs through the length of a board,
parallel to the grain.
WORKPIECE
The item to which the cutting operation is being
applied.

PRODUCT SPECIFICATIONS

MOTOR
Type
Amps
Voltage
Hz
RPM
Overload Protection
SAW
Blade Size 10" (255 mm)
Maximum Cut Depth @ 90º
Maximum Cut Depth @ 45º
Table size (width x depth):
480 mm)

UNPACKING AND CHECKING CONTENTS

WARNING: To avoid injury from unexpected
starting or electrical shock, do not plug the
power cord into a source of power. This cord must
remain unplugged whenever you are working on
the table saw.
Your table saw is shipped complete in one carton.
1. Unpacking and Checking Contents. Separate
all parts from packing materials
and check each one with the illus tration and the
parts list to make certain all
items are accounted for before discarding any
packing material.
WARNING: If any parts are missing, do not
attempt to assemble the table saw.
Do not plug in the power cord or turn on the
switch until the missing parts are
obtained and are installed correctly.
PARTS IN CARTON
1. Table Saw Assembly
2. Mitre gauge
3. Rip fence and handle
4. Blade elevation wheel handle
12
Universal
15
120
60
4800
YES
2-7/8" (73 mm)
2-23/64" (60 mm)
26" x 18-7/8" (660 x