Matrix JF72553B Traduction De La Notice Originale page 8

enables better control of the tool in unexpected
situations.
14. Use safety equipment. Always wear eye
protection. Dust mask, non-skid safety shoes,
hard hat, or hearing protection must be used for
appropriate conditions.
TOOL USE AND CARE
15. Use clamps or other practical way to
secure and support the work piece to a stable
platform. Holding the work by hand or against
your body is unstable and may lead to loss of
control.
16. Do not force tool. Use the correct tool for
your application. The correct tool will do the
job better and safer at the rate for which it is
designed.
17. Do not use tool if switch does not turn it on
or off. Any tool that cannot be controlled with
the switch is dangerous and must be repaired.
18. Disconnect the plug from the power source
before making any adjustments, changing
accessories, or storing the tool. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
19. Store idle tools out of reach of children and
other untrained persons. Tools are dangerous
in the hands of untrained users.
20. Maintain tools with care. Keep cutting tools
sharp and clean. Properly maintained tools with
sharp cutting edges are less likely to bind and are
easier to control. Do not use a damaged tool.Tag
damaged tools"Do not use" until repaired.
21. Check for misalignment or binding of
moving parts, breakage of parts,and any
other condition that may affect the tool's
operation. If damaged,have the tool serviced
before using. Many accidents are caused by
poorly maintained tools.
22. Use only accessories that are
recommended by the manufacturer for your
model. Accessories that may be suitable for
one tool may become hazardous when used on
another tool.
SERVICE
23. Tool service must be performed only by
qualified repair personnel. Service
or maintenance performed by unqualified
personnel could result in a risk of injury.
24. When servicing a tool, ask that only
identical replacement parts be used.
Use of unauthorized parts or failure to follow
Maintenance instructions may create
a risk of electric shock or injury.
∙ HANDLE THE CORD CAREFULLY. Never
carry your tool by the cord or pull on the cord
to unplug it. Protect the cord from potential
sources of damage: heat, oil & solvents, sharp
edges, or moving parts. Replace damaged cords
immediately.
∙ WHEN WORKING OUTDOORS, USE AN
OUTDOOR-RATED EXTENSION CORD. An
extension cord rated for outdoor use must be
marked "W-A" or "W".
∙ DO NOT EXPOSE ELECTRICAL POWER TOOLS
TO MOISTURE. Rain or wet conditions can cause
water to enter the tool and lead to electric shock.
∙ STORE IDLE EQUIPMENT. Store equipment in a
dry area to inhibit rust.
Equipment also should be in a high location or
locked up to keep out of reach of children.
∙ MAINTAIN TOOLS WITH CARE. Keep tools
sharp and clean for better and safer performance.
Follow instructions for lubricating and changing
accessories. Keep handles dry clean and free from
oil and grease.
∙ AVOID UNINTENTIONAL STARTING. Be sure
8