Briteq BT-575S Mode D'emploi page 8

ENGLISH
 HOW TO SET THE THE RIGHT STARTING ADDRESS:
Refer to the previous chapter (DMX-512 address setting) to learn how to set the starting address on this unit.
The starting address of each unit is very important. Unfortunately it is impossible to tell you in this user
manual which starting addresses you have to set because this completely depends on the controller you will
use... So please refer to the user manual of your DMX-controller to find out which starting addresses you
must set.
DMX-CONFIGURATION OF BT575S:
16 channel modus
BRITEQ® 11/73
OPERATION MANUAL
BT575S
ENGLISH
1. For DMX reset, put DMX value of CH-8 & CH-16 to 255, the unit will reset after about five seconds.
For lamp on, put DMX value of CH-8 to 247 & CH-16 to 255.
For lamp off, put DMX value of CH-8 to 239 & CH-16 to 255.
2. For color sound activated, put DMX value of CH-6 & CH-7 to 255.
For gobo sound activated, put DMX value of CH-8 & CH-9 to 255.
8 channel modus
BRITEQ® 12/73
OPERATION MANUAL
BT575S