General; Troubleshooting Table - Asko HI1995G Mode D'emploi

TROUBLESHOOTING

General

Troubleshooting table

Symptom
The display lights up when
the hob is activated for the
first time.
The fan runs on for several
minutes after the hob has
been switched off.
A slight smell is noticeable
the first few times the hob is
used.
You can hear a ticking sound
in your hob.
The pans make a noise while
cooking.
You have switched on a
cooking zone, but the display
keeps flashing.
A cooking zone suddenly
stops working and you hear
a signal.
EN 30
If you notice a crack in the glass top (however small), switch the hob
off immediately, unplug the hob, turn off the (automatic) fuse switch(es)
in the meter cupboard or, in the event of a permanent connection,
set the switch in the power supply lead to zero.) Contact the service
department.
If the appliance does not work properly, this does not always mean that
it is defective. Try to deal with the problem yourself first by checking
the points mentioned below.
Possible cause
This is the standard set-up
routine.
The hob is cooling.
The new appliance is heating
up.
This is caused by the
capacity limiter on the front
and back zones. Ticking can
also occur at lower settings.
This is caused by the energy
flowing from the hob to the
saucepan.
The pan you are using is
not suitable for induction
cooking. or has a diameter of
less than 12 cm.
The preset time has ended.
Solution
Normal operation.
Normal operation.
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
Normal operation.
At high settings this is
perfectly normal for some
pans. It will not damage either
the pans or the hob.
Use a suitable pan, see page
11 and 12.
Switch the bleep off by
pressing the + or - button of
the timer.