Asko HI1995G Mode D'emploi page 31

TROUBLESHOOTING
Symptom
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
'br' appears in the display
and the touch controls are
not working.
Error code F00.
Error code F0 up to and
including F6 and FC.
Error code F7.
Error code F8 and F08.
Error code F9 and/or
continuous beep.
Error code F99.
Error code FA.
Error code FAN.
Other error codes.
Possible cause
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
The bridge function is
activated.
The control panel is dirty or
has water lying on it.
Defective generator.
The ambient temperature is
not good.
Appliance over heated.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
You have pressed two or more
buttons at the same time.
Mains voltage is too low.
Air circulation not good.
Defective generator.
Solution
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Deactivate the bridge function
(see pagina 17).
Clean the control panel.
Contact the service
department.
Switch off all heat sources in
the vicinity of the cooking plate.
The appliance has been
switched off because of over
heating. Let the appliance
cool down and start again on
a lower setting.
Let your connection be
changed.
Do not operate more than one
button at the same time.
Contact your energy supplier.
Make sure the venting holes
under the cooking plate are
open.
Contact the service
department.
EN 31