Installing Supply Lines To The Condenser Unit - Dometic COOLAIR SP950T Instructions De Montage

CoolAir SP950T
You can connect the unit to the battery via the lorry's terminal block or directly.
The terminal block is to be preferred for the connection. Ask your vehicle
manufacturer for the specifications of the terminal block.
➤ Lay the supply line and connect it to the vehicle (red line to plus, black line to
minus).
➤ Plug in the supply line plug into the socket of the air conditioning roof unit
supply line.
➤ To relieve strain on the supply line, secure it with a cable tie, e.g. to the cab
roof.
7.7

Installing supply lines to the condenser unit

Observe the following instructions when installing the supply lines:
• Also observe the installation instructions for the condenser unit.
• The maximum cable length between the evaporator and condenser unit is
4.20 m (fig. 6, page 5).
• When installing and bending supply lines, avoid narrow radii. Use a suitable
round object as a bending aid. A radius which is too narrow will buckle the
refrigerant line, and the parking cooler will be inoperable.
➤ Shorten any supply line which is not needed by bending a curve.
➤ Apply packing compound (fig. 7 1, page 5) to prevent water entering
between the rear wall of the truck and the clip.
I
NOTE
If you wish to avoid damaging the rear wall of the truck (drilling a hole), you can
also apply the clip using a suitable adhesive. Observe the instructions provided
by the adhesive manufacturer.
➤ Fasten the supply lines to the rear wall of the truck using the clips provided
(fig. 7, page 5).
➤ Insert the corrugated piping in the holder provided (fig. 7 2, page 5).
➤ Put the cover on (fig. 7 4, page 5).
EN
Installation
21