Set-Up And Operation; Safety Features - EUROM MICA-HEAT-WAVE 1600 Manuel D'utilisation

Remove all packaging material and keep out of reach of children. After removing packaging,
check the appliance for damage or other signs that could indicate a fault/defect/malfunction.
In case of doubt, do not use the appliance, but contact your vendor for inspection or
replacement.
Do not use the heater before it has been installed in accordance with the following
Attach the feet supplied to the underside of the heater:

Turn the heater upside down. Place a blanket (or something similar) under the heater to
prevent damage!

Slide the feet into place on the sides. This will ensure that the threaded holes will align
correctly.

Securely attach the feet to the heater using the self-tapping screws.

Return the heater to the upright position.

Make sure a working heater is always placed on a solid, flat and horizontal surface. Deep-
pile carpeting is unsuitable!

Set-up and Operation


Make sure the heater is turned off (control button to O) and that the thermostat dial is set
to maximum (clockwise, as far as it will go). Now plug into an earthed, correctly
functioning 220-240V / 50Hz socket. The pilot light will switch on.

Turn the control button to the desired position:
I = low power heating (600 Watt)
II = medium power heating (1000 Watt)
III = full power heating (1600 Watt)
The heater will now start to heat the space.

When the space has reached the desired temperature, turn the thermostat dial
anticlockwise slowly until you hear a click. In this position, the thermostat will maintain the
current temperature by turning the heater on and off for a top-up, if necessary. If so
desired, you can now switch to a lower power level. For higher temperatures, turn the
thermostat dial clockwise, for lower temperatures anticlockwise.

To switch off the heater, turn the control button to O and unplug.

Safety features

The heater is fitted with a tipping safeguard which automatically shuts off the appliance if it
inadvertently falls over. The heater will function as normal once it is returned to its upright
position but you are advised to switch if off, unplug and check it for damage before using
again. Do not use the heater in case of damage or malfunctioning. Have the appliance
inspected/repaired!
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater off. This
may occur if the heater cannot give off enough heat or if it cannot draw in enough fresh air.
As mentioned above, this is generally caused by (partially) covering the heater, obstructing
the air intake and/or outlet grills or installing the heater too close to a wall or something
similar. When the heater has cooled down sufficiently, it will in principle start again
automatically, however if you do not remove the cause of the cut-off then this will probably be
repeated. Regular overheating can give rise to irreparable damage.
This heater may not be used while suspended!!!
instructions!
16