Connecting The Power Cord (1) - Pioneer AVIC-D3 Manuel D'installation

Connecting the System

Connecting the power cord (1)

Note:
Depending on the kind of vehicle, the
function of *3 and *5 may be different.
In this case, be sure to connect *2 to *5
and *4 to *3.
*1
*3
*5
C a p ( * 1 )
When not using this terminal,
do not remove the cap.
Yellow (*3)
Back-up
(or accessory)
Red (*5)
Accessory
(or back-up)
ISO connector
Yellow/black
If the vehicle can send a mute signal to this terminal,
the mute function can be activated on this navigation
system when the terminal is connected to *8.
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
9
Notes:
• When a subwoofer (*9) is connected to this navigation
• When using a subwoofer of 70W (2Ω), be sure to con-
*2
*4
Yellow (*2)
To terminal always supplied
with power regardless of
ignition switch position.
Red (*4)
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
system instead of a rear speaker, change the rear output
setting in the Initial Setting. (Refer to the Operation
Manual.) The subwoofer output of this navigation sys-
tem is monaural.
nect with violet and violet/black leads of this naviga-
tion system. Do not connect anything with Green and
Green/Black leads.
Connect leads of the same
colour to each other.
Speaker leads
Front left +
White:
White/black: Front left ≠
Front right +
Grey:
Grey/black: Front right ≠
Rear left + or Subwoofer + (*9)
Green:
Green/black: Rear left ≠ or Subwoofer ≠ (*9)
Rear right + or Subwoofer + (*9)
Violet:
Violet/black: Rear right ≠ or Subwoofer ≠ (*9)