Arjohuntleigh Flowtron Hydroven 12 Notice D'utilisation page 3

To be used only under the direction of a physician.
100% Latex Free.
For use with
ArjoHuntleigh Flowtron
pump only.
12
Refer to the
Flowtron Hydroven 12
316903EN for complete information on using the
pump and garments.
Garments and Garment Inserts
Arm Garment
Leg Garment
Applying the Garments
1. Make sure the garment is the correct size for the
limb, and that a garment insert is used if
necessary.
2. Undo the zip on the garment.
3. If a garment insert is fitted to the garment, fully
fasten one of the zips between the garment and
insert, leaving the other unfastened.
4. Before applying the garment (and insert, if
fitted) to the limb, zip up the first 150 mm (6")
of the unfastened garment zip. Put the garment
(and insert) onto the limb and fully fasten the
zip.
5. Make sure the patient is in a comfortable
position with the limb supported or elevated as
necessary.
6. Connect the garment(s) to the two push-fit,
polarised 12-way connectors on the pump. If
only one garment is used, fit the rubber cover to
the lower pump connector.
7. Connect the pump to a suitable mains power
supply. Switch on the pump.
8. Refer to the
Flowtron Hydroven 12
Manual for further information on changing the
therapy settings on the pump control panel.
Arm and Leg Garments
®
Hydroven
User Manual
Arm Garment with Insert
Leg Garment with Insert
User
Warnings
• Do not apply the garment to the limb unless it is
partially zipped, as you may damage the
garment zip.
• Do not undo the zips or attempt to remove the
garments during the therapy session or you may
damage the zips. Make sure the therapy session
has stopped and the garments have deflated
before you remove the garments.
• Do not stand or walk with the garments fitted.
• In the event of a power failure or fault whereby
the garment remains inflated, disconnect the
tubeset(s) in order to deflate the garment(s) and
then remove the garment(s) from the limb(s).
Cleaning the Garment
Wipe down using a neutral detergent or
soap powder at 40°C (104°F).
Do not iron.
Do not dry clean.
Do not tumble dry.
Do not machine wash. Air dry thoroughly.
Disinfecting the Garment
After cleaning, wipe complete garment over
using 70% isopropyl alcohol wipe or a
chlorine-releasing agent at 1000 p.p.m.
available chlorine.
Do not use phenol or phenol-derivative
disinfectant.
Rinse with clean water to remove any residue. Air
dry thoroughly.
Sterilising the Garment
After cleaning, gas sterilisation is possible.
Do not exceed 51°C (124°F). Do not autoclave.
Cleaning the Tubeset
Use a soft brush. Air dry only.
Do not immerse in water. Do not machine wash.
EN