Hendi 205914 Mode D'emploi page 9

Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are
still unable to solve the problem, please contact the supplier/service provider.
Problems
The appliance does not switch ON.
The main switch (1) does not light up
in green.
The appliance does not heat up and
temperature indicator (2) does not
light up. But main switch (1) lights up
in green.
Appliance does not reach the set tem-
perature after long frying time.
In case of any doubt, always contact your supplier!
Warranty
Any defect affecting the functionality of the ap-
pliance which becomes apparent within one year
after purchase will be repaired by free repair or re-
placement provided the appliance has been used
and maintained in accordance with the instructions
and has not been abused or misused in any way.
Your statutory rights are not affected. If the appli-
ance is claimed under warranty, state where and
Discarding & Environment
When decommissioning the appliance, the prod-
uct must not be disposed of with other household
waste. Instead, it is your responsibility to dispose to
your waste equipment by handing it over to a des-
ignated collection point. Failure to follow this rule
may be penalized in accordance with applicable
regulations on waste disposal. The separate col-
lection and recycling of your waste equipment at
the time of disposal will help conserve natural re-
Possible causes
Power plug is not connected properly
with the electrical power outlet.
The main switch (1) is not pressed.
The rear support with heating ele-
ment (4) is not properly mounted.
Inside microswitch is defective.
Hi-limiter (thermal cut-out) activates.
Hi-limiter (thermal cut-out) defective.
Temperature control (3) defective.
Heating element defective
Temperature control (3) defective.
when it was purchased and include proof of pur-
chase (e.g. receipt).
In line with our policy of continuous product devel-
opment we reserve the right to change the product,
packaging and documentation specifications with-
out notice.
sources and ensure that it is recycled in a manner
that protects human health and the environment.
For more information about where you can drop off
your waste for recycling, please contact your local
waste collection company. The manufacturers and
importers do not take responsibility for recycling,
treatment and ecological disposal, either directly
or through a public system.
Possible solutions
Make sure the power plug is connect-
ed properly with the electrical power
outlet.
Press the main switch (1) to the "I"
position.
Properly placed the rear support with
heating element (4) on the oil contain-
er (5).
Contact your supplier.
Reset the Hi-limiter (thermal cut-out)
(See ==> RESET the thermal cut-out).
Contact your supplier.
Contact your supplier.
Contact your supplier.
Contact your supplier.
EN
9