Hendi 205914 Mode D'emploi page 6

Installation
• Place the appliance on a level, stable, clean,
heat-resistant and dry surface with its rubber
feet.
• Carefully install the back support with heating
element (4) on the rear edge of the oil container.
• Place the bottom grid (9) at the bottom of the oil
container (5).
• Set up the frying grid holder (8) on either right or
left side of the oil container (5).
Note:
1. Make sure that the rear support is in the cor-
rect position & properly inserted into 2 slots at 2
sides of the oil container (5).
Main parts of the appliance
EN
1. Main switch (Green) [ON (I) / OFF (0)]
2. Temperature indicator (Orange)
3. Temperature control
4. Detachable rear support with heating element
5. Oil container (400x400x(H)160 mm)
Use
• Make sure the oil drain tap is closed.
• Remove the plug from the socket.
• Make sure the oil container is clean and dry and
no water inside.
6
2. The appliance should be placed in a safe position
in your kitchen before use due to heat hazard
when in use.
6. Oil drain tap
7. Frying grid (2x 354x383x(H)102 mm)
8. Frying grid holder (1x 423x446x(H)40 mm)
9. Bottom grid (1x 390x365x(H)40 mm)
• Carefully fill the oil container with oil between the
"MIN" and the "MAX" marking.
• Plug the earthed plug into an earthed socket.
• You can now use the appliance.