Specifications - Metcal MX-500 Manuel D'utilisation

POWER SUPPLY
Tip-to-Ground Potential
Tip-to-Ground Resistance
Idle Temperature Stability
Ambient Operating Temp.
Maximum Enclosure Temp. 150 ° F (65°C)
Thermal Switch
Input Line Voltage
Input Line Frequency
Fuse
Output Power
Output Frequency
Auto-Off Feature
Power Cord (3-wire)
W x H x D
Weight
Standards Compliance
SOLDERING HANDPIECE
Weight
Handle Cord Assembly
ESD Materials
TALON HANDPIECE
Weight (handle)
Handle Cord Assy
ESD Materials
DESOLDERING HANDPIECE
Input Air Pressure
Vacuum
Weight
Handle Cord Assembly
ESD Materials
TIP CARTRIDGES
STTC Startup Power
Maximum Temperature
18
Copyright © 1998, Metcal, Inc. All Rights Reserved 7027-0400 Rev A
SYSTEM SPECIFICATIONS
< 2 mV True RMS, 50-500 Hz
< 2 ohms DC, unit on
± 2° F (± 1.1°C) Still air
50 - 104° F (10 - 40 °C)
Setpoint at 150 ± 3° F (66 ± 1.2°C)
Auto-reset once cooled to 110° F (43°C)
90 - 130 VAC (-11)
45 - 70 Hz (-11)
250V, 1.25 A, "Slo-Blo"
40 Watts maximum
@ 72°F (22°C) ambient temperature
13.56 MHz
10 millisecond lag time
6 ft (183 cm) 18/3 SJT
5.3" x 9.5" x 4.7" (13.5cm x 24.1cm x 11.9cm)
7.5 lbs. (3.41kg)
MIL-STD-2000, -1686, -45743E, WS-6536D/E
2 oz (56.7 g)
6 ft (183 cm) carbon loaded silicone, shielded
10 5 - 10 12 ohm/square as per ASTM D257
(10 5 - 10 9 ohm/square where possible)
2 oz (56.7 g)
6 ft (183 cm)
Carbon loaded silicone, shielded
10 5 - 10 12 ohm/square as per ASTM D257
(10 5 - 10 9 ohm/square where possible)
60-100 psig required
18 inches Hg minimum
10.5 oz (298 g)
6 ft (183 cm) carbon loaded silicone, shielded
10 5 - 10 12 ohm/square as per ASTM D257
(10 5 - 10 9 ohm/square where possible)
500 Series > 25 Watts
600 Series > 25 Watts
700 Series > 30 Watts
500 Series ≤ 575°F (302°C)
600 Series ≤ 675°F (352°C)
700 Series ≤ 775°F (405°C)
190-260VAC (-21)
50-60Hz (-21)