Inserting Tip Cartridges Into The Solder/Rework Handpiece - Metcal MX-500 Manuel D'utilisation

INSERTING TIP CARTRIDGES INTO THE SOLDER/REWORK HANDPIECE

1. Make sure the system is turned off.
2. Insert the tip cartridge into the soldering handpiece by pushing in the "back end"
of the cartridge (the end without the tip) as far as it will go. You will feel a slight
click as it locks into place
NOTE: EVEN AFTER THE SYSTEM IS TURNED OFF OR TIMED OUT, THE TIP CARTRIDGE MAY BE HOT
1. Make sure the system is turned off.
2. Pull out the cartridge using the Cartridge Removal Pad
3. Push a new cartridge into the handle as discussed above.
4. Push the power switch "on". The new cartridge should heat up to temperature
quickly.
DO NOT USE METAL TOOLS SUCH AS PLIERS TO REMOVE TIP CARTRIDGES!
6
Copyright © 1998, Metcal, Inc. All Rights Reserved 7027-0400 Rev A
THIS
REPLACING TIP CARTRIDGES
NOT THIS