Equipment; Installation - Casada BMS BETASONIC Mode D'emploi

Equipment

~ MAIN BODY DIAGRAM (FRONT)
MAIN BODY DIAGRAM (REAR) }
Remote Control Port
Main Power Switch
Safety Fuse
Power Cord Socket
USB Port
28
Cushion
Shoulder airbags
Remote control & holder
Backrest cushion
Arm airbag
Seat cushion
Side panel
Legrest
Wheels
Footrest

Installation

1| OPENING THE PACKAGING AND TAKING OUT THE ACCESSORIES
Remove the carton
a) Remove the plastic bands of the outer packaging of the massage chair and lift the outer
packaging upwards.
b) Take out the inside packaging material.
c) Install the backrest cushion and pillow.
d) Scope of delivery in the accessory packaging: operating manual, power cable, remote con-
trol and remote control holder
2| INSTALL THE LEG FRAME
(a)
Connecting rod
Bolt
Square tube
(d)
a) Take out the footrest, located in the back of the massage chair and place it in front of the chair.
b) There is a thread on the right and left on the front of the seat. Take the footrest, hold it flush
with the thread and fasten both sides with the supplied screws. Please insert the plastic supplied
washers between.
c) Turn on the chair and uplift the footrest to the highest position. Afterwards disconnect it from the
power source again. Now connect the air tubes of the footrest with those of the chair using the
same colours. Finally, plug together the connectors for the power supply of the footrest
d) Now connect the rod, which is located in the back centre of the foot part, with the edge iron
protruding from the chair with the aid of the associated bolts and secure it with the safety clip.
e) Finally connect the chair to the power supply and let it go back to the starting position.
Power supply connectors
Connect air tubes (c)
(b)
Buckle
(e)
29