Warranty | Environment And Recycling; Warranty - Stiebel Eltron SB 300 E Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARRANTY | ENVIRONMENT AND RECYCLING

17. Warranty

DHW SOL AR & INDIRECT STOR AGE TANKS
All SB 150 S, SB 200 S, SB 300 E, SB 400 E, SBB 300 S, SBB 400 S, SBB 300 Plus, SBB 400 Plus,
& SBB 600 Plus Model s
Subject to the terms and conditions set forth in this limited
lifetime warranty, Stiebel Eltron, Inc. (the "Manufacturer")
hereby warrants to the original purchaser (the "Owner") that
each storage tank (the "Tank") shall be free from defects in the
Manufacturer's materials or workmanship for a period of:
1. (10 Years) from the date of purchase for single, two-, and
three-family residential installations
2. (5 Years) from the date of purchase for all other
installations
3. (Excluded) sacrificial or electronic anode
As Owner's sole and exclusive remedy for the above warranty,
Manufacturer shall, at the Manufacturer's discretion, either
factory repair or replace the defective Tank with a replacement
unit or part(s) with comparable operating features.
Manufacturer's maximum liability under all circumstances shall
be limited to the Owner's purchase price for the Tank.
This limited warranty shall be the exclusive warranty made by
the Manufacturer and is made in lieu of all other warranties,
express or implied, whether written or oral, including, but
not limited to warranties of merchantability and fitness for
a particular purpose. Manufacturer shall not be liable for
incidental, consequential or contingent damages or expenses
arising directly or indirectly from any defect in the Tank or the
use of the Tank. Manufacturer shall not be liable for any water
damage or other damage to property of Owner arising, directly
or indirectly, from any defect in the Tank or the use of the Tank.
Manufacturer alone is authorized to make all warranties on
Manufacturer's behalf and no statement, warranty or guarantee
made by any other party shall be binding on Manufacturer.
Manufacturer shall not be liable for any damage whatsoever
relating to or caused by:
1. any misuse or neglect of the Tank, any accident to the Tank,
any alteration of the Tank, or any other unintended use;
2. acts of God and circumstances over which Manufacturer
has no control;
3. installation of the Tank other than as directed by
Manufacturer and other than in accordance with
applicable building codes;
4. improper installation and/or improper materials used
by any installer and not relating to defects in parts or
workmanship of Manufacturer;
5. failure to maintain the Tank or to operate the Tank in
accordance with the Manufacturer's specifications;
6. failed components not originally installed by the
Manufacturer as a part of the unit at the time of sale;
7. exposure to freezing conditions;
This Warranty is valid for all purchases on or after June 15, 2019.
This Warranty is valid for U.S.A. & Canada only. Warranties
may vary by country. Please consult your local Stiebel Eltron
Representative for the Warranty for your country.
www.stiebel-eltron-usa.com
LIMITED WARRANT Y
8. exposure to harmful chemicals, contaminated water,
corrosive fluids or atmosphere, liquids harmful to steel
tubing including improperly applied or maintained heat
transfer fluids.
9. utilizing the tank as an open loop heat exchanger, e.g.,
do not use in drainback systems or continually pass fresh
potable water through the units internal heat exchanger.
10. installing the Tank in a closed system without a properly
sized and installed thermal expansion tank;
11. operating the Tank without the factory installed
sacrificial anode;
12. operating the Tank under fluctuating or excessive water
pressure or in the event the Tank is supplied with non-
potable water for any duration;
13. operating the Tank when it is empty or partially full of
potable water;
14. Installing and operating the Tank outdoors;
15. operating the Tank at temperatures higher than
recommended by Manufacturer;
16. (SB E models) replacing the electric heating element
with a unit not manufactured by Stiebel Eltron or greater
in power than the originally installed element;
17. (SB E models) connecting the Tank to improper voltage
or service;
Should owner wish to return the Tank to manufacturer for
repair or replacement under this warranty, Owner must first
secure written authorization from Manufacturer. Owner shall
demonstrate proof of purchase, including a purchase date, and
shall be responsible for all removal and transportation costs.
If Owner cannot demonstrate a purchase date this warranty
shall be limited to the period beginning from the date of
manufacture stamped on the Tank. Manufacturer reserves
the right to deny warranty coverage upon Manufacturer's
examination of the Tank. This warranty is restricted to the
Owner and cannot be assigned.
Some States and Provinces do not allow the exclusion or
limitation of certain warranties. In such cases, the limitations
set forth herein may not apply to the Owner. In such cases this
warranty shall be limited to the shortest period and lowest
damage amounts allowed by law. This warranty gives you
specific legal rights and you may also have other rights which
vary from State to State or Province to Province.
Owner shall be responsible for all labor and other charges
incurred in the removal or repair of the Tank in the field. Please
also note that the Tank must be installed in such a manner that
if any leak does occur, the flow of water from any leak will not
damage the area in which it is installed.
17 West Street
West Hatfield, MA 01088
800.582.8423
TOLL FREE
413.247.3380
PHONE
413.247.3369
FAX
info
stiebel-eltron-usa.com
@
www.stiebel-eltron-usa.com
SB 300-400 E |
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sb 400 e

Table des Matières