Rotary Hammer Safety Warnings - Makita HR4003C Manuel D'instructions

ENGLISH
(Original instructions)
1 Switch trigger
2 Switch button
3 Adjusting dial
4 Change lever
5 Pointer
6 Power-ON indicator lamp
(green)
SPECIFICATIONS
Model
Carbide-tipped bit
Capacities
Core bit
No load speed (min
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing program of research and
development, the specifications herein are subject to
change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
Explanation of general view
7 Service indicator lamp (red)
8 Side handle
9 Clamp nut
10 Side grip
11 Bit shank
12 Bit grease
13 Bit
HR4003C
–1
)
1,450 – 2,900
6.2 kg
ENE044-1
ENF002-2
GEA010-1
HR4013C
40 mm
105 mm
250 – 500
479 mm
6.8 kg

ROTARY HAMMER SAFETY WARNINGS

1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
8. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Do not point the tool at any one in the area when
operating. The bit could fly out and injure
someone seriously.
14 Release cover
15 Depth gauge
16 Lock button
17 Blow-out bulb
HR5202C
52 mm
160 mm
150 – 310
1,100 – 2,250
599 mm
10.9 kg
/II
HR5212C
11.9 kg
GEB007-7
5