Heidolph 1000 Mode D'emploi page 20

E
♦ Secure lower half (C) on heater module; use 2 ea. knurled bolts from your hardware bag.
♦ Place hood (D) on lower part.To do so loosen fastening screw (H) by turning counter-
clockwise until gap is ca. 6mm. Align hinges to an upright position. While mounting hood
(D) place threaded part of fastening screw (H) in slash of hinges (J).
♦ Tighten fastening screws (H).
♦ Open hood and plug deflector plate (F) in cutouts of lower half (C). This plate is important
for proper distribution of hot air under the hood.
♦ heater module power supply is independent of shaker and mixer. Heating module comes
with its own power cord. Use handle (L) to open/close hood (D).
♦ When closed, the integrated magnets (M) keep the hood (D) in position.
20