Bull NovaScale T860 E1 Guide De L'utilisateur page 211

Code
Message d'erreur
d'erreur
02D1 System Memory
caching limit.
02F4 EISA CMOS not write able.
02F5 DMA Test Failed.
02F6 Software NMI Failed.
02F7 Fail-safe Timer NMI Failed.
0611 IDE configuration changed
0612 IDE configuration error - device disabled
0613 Com A configuration changed
0614 Com A config. error - device disabled
0615 Com B configuration changed
0616 Com B config. error - device disabled
0B22 CPUs are installed out of order.
0B28 Unsupported CPU detected on CPU Socket
1.
0B29 Unsupported CPU detected on CPU Socket
2.
0B42 Resource Conflict
0B43 Warning: IRQ not configured
0B45 System configuration Data Write Error
0B50 Processor #1 with error taken off line.
0B51 Processor #2 with error taken off line.
0B5F Forced to use Processor with error
0B60 DIMM group #1 has been disabled
0B61 DIMM group #2 has been disabled
0B62 DIMM group #3 has been disabled
0B63 DIMM group #4 has been disabled
0B64 DIMM group #5 has been disabled
0B65 DIMM group #6 has been disabled
0B6F DIMM group with error is enabled.
0B70 The error occurred during temperature
sensor reading.
0B71 System Temperature out of the range.
0B74 The error occurred during voltage sensor
reading.
0B75 System voltage out of the range.
0B80 BMC Memory Test Failed.
0B81 BMC Firmware Code Area CRC check
failed.
0B82 BMC core Hardware failure
0B83 BMC 1BF or 0BF check failed.
0B8A BMC SEL area full.
Action recommandée
exceeds the CPU's Contactez le service client.
Vérifiez la configuration IDE.
Vérifiez la configuration du port COM A.
Vérifiez la configuration du port COM B.
Contactez le service client pour remplacer la CPU.
Assurez-vous que le serveur prend en charge la CPU.
En cas de doute, contactez le service client.
Contactez le service client.
Le démarrage du système a été forcé. Contactez le
service client.
Contactez le service client.
Contactez le service client.
Contactez le service client pour remplacer le ventilateur.
Contactez le service client.
Mettez le serveur hors tension puis sous tension pour le
démarrer.
contactez le service client.
Lancez le SETUP, sélectionnez [Server] - [Event Log
Configuration] - [Clear All Error Logs] et appuyez sur la
touche Entrée du clavier pour effacer le contenu des
journaux d'événements.
Si cette action ne corrige pas l'erreur,
8-11