Controls And Components Of The Piezon Master 400; Connecting The Piezon Master 400 - EMS Piezon Master 400 Mode D'emploi

Page E-5/E-19

Controls and components of the Piezon Master 400

1 Housing
2 Power switch
3 Equipment-on lamp, green
4 Control lamp, yellow
5 "Water" knob for controlling the water flow rate
6 "Power" knob for controlling the ultrasonic power
7 ENDO or IRRIGATION/SCALING rocker switch
8 Handpiece hose with quick-link coupling for Piezon handpieces
9 Handpiece holder
10 Irrigating liquid bottle
11 Screw-cap for bottle
12 Bayonet face plate for the screw-cap
13 Red washer for the screw-cap
14 Bottle holder
15 O-ring for the small nipple in the bottle holder
16 Silicone washer for the bottle holder
17 Bottle holder cap
18 Footswitch
19 Torque wrench
20 Power cable
21 Power socket

Connecting the Piezon Master 400

Please note - It is advisable to keep the original packaging of the unit. Keep the
packaging for storing or transporting the unit.
You require a power supply in order to connect the Piezon Master 400.
Use the power cable (20) to connect the unit to the power supply. Before connecting,
check that the rated voltage specified on the back of the unit corresponds with the
local line voltage of your dental office. The rated voltage of the unit must be the same
as the local line voltage, otherwise the unit can be damaged. Plug the power cable
(20) into the power socket (21) on the back of the unit and then into a mains power
socket.
Piezon Master 400