Kensington 33367 Guide D'instructions page 6

or Clone mode.
Click Extended (dualview) to configure the external monitor in Extended
mode with just one click. Default setting for the Extended mode positions
the external monitor on the right side of the primary display.
NOTE: The primary display corresponds to the display of your laptop
unless it is configured differently through the Display Properties interface
of the operating system.
When in Extended (dualview) mode you can select the position of the
external monitor how you want to see it compared to the monitor of your
primary display by clicking on the dualview Settings and select from the
displayed menu.
In Clone mode the resolution of the external monitor can not be modified
by the user but is automatically selected to better match the display
resolution of the laptop connected to the Docking Station. To change the
screen resolution of the laptop use the Display Properties interface of the
operating system. Click Advanced to activate this interface.
When you want to switch from Clone mode to Extended (dualview) mode
you can either click on dualview Settings and select the position of the
external monitor or just click on Extended (dualview): in this case the last
settings of the Extended mode are retrieved.
The change from Extended (dualview) mode to Clone mode and vice versa
takes few seconds to be completed.
3 To change the screen resolution of the external display select Screen
Resolution and select one of the options listed by the application.
For example, selecting 1280x1024 means that the video port will
provide video output of 1280 pixels by 1024 pixels. The resolutions
displayed in the user interface are a combination of those supported
by the docking station and those supported by the external monitor
connected to the docking station. If the external monitor does not
provide the information related to the supported resolutions the
docking station will adopt a default list of display resolutions.
4 To change the color quality of the external display when in Extended
(dualview) mode, select Color Quality and Medium (16 bit) or Highest
(32 bit) color depth.
5 To rotate the view of the external screen select Screen Rotation and
one of the possible options, Rotated Left, Rotated Right or Inverted.
Select Normal to switch to the normal view.
Note: the refresh rate of the external monitor can only be modified
through the standard interface of the operating system and not through
the utility provided with the docking station.
6 To turn off the video signal from the Docking Station, select "Disable":
to turn the video signal back on, select either the Extended (dualview)
or Clone.
If you use multiple Docking Stations with a single notebook—for example,
one at work and one at home—the video settings for each Docking
Station are saved when you disconnect the notebook. So you can have
your Docking Station at work set up for Extended (dualview) mode while
your Docking Station at home is configured for Clone mode, and those
settings will be retained each time you use the Docking Station with your
notebook.
If you share the Docking Station with different laptops, video settings
preference for each laptop will be maintained.
How Standby or Hibernate Mode Affects Devices
Attached to the Docking Station
External Monitors
When the Docking Station is connected to a notebook and an external
monitor, if the notebook goes into Standby or Hibernate Mode, the
external monitor display goes blank.
Note: Depending on your notebook settings, the notebook might go into
Standby or Hibernate Mode when you close the lid.
When the notebook returns to an active state, the external monitor
display keeps the same settings it had before the notebook went into
Standby or Hibernate Mode. However, if the external monitor was set
for Extended (dualview), windows that were previously on the external
monitor will not move back to that secondary monitor. Also, if the
external monitor is in Extended (dualview) and the notebook requires
a login after Standby or Hibernate Mode, , the loging screen appears on
both primary notebook monitor and on the external monitor.
5