Shure GLXD4R Guide De L'utilisateur page 11

Locking the Transmitter Power Switch
Starting with the transmitter set to off, press and hold the LINK button
while turning on the transmitter. Continue to hold the link button until the
lock icon appears on the receiver LCD. Repeat sequence to unlock.
Optionally, the transmitter power switch can be remotely locked from the
receiver front panel:
Simultaneously press and hold the group and link buttons for approxi-
mately 2 seconds until the flashing lock icon appears on the receiver LCD.
Repeat sequence to unlock.
Identifying Linked Transmitters and
Receivers with Remote ID
Use the Remote ID feature to identify linked transmitter and receiver pairs
in multiple receiver systems. When Remote ID is active, the receiver LCD
will blink and display ID. The status LED of the corresponding transmitter
will alternately flash red and green for approximately 45 seconds.
To activate Remote ID:
1. Momentarily press the link button on the transmitter or receiver.
2. The LCD of the linked receiver will blink and display ID and the
status LED on the linked transmitter will flash red/green.
3. To exit Remote ID mode, momentarily press the
link button or allow the function to timeout.
Manually Selecting a Group and Channel
Specific groups and channels can be assigned to the receiver instead of
using the automatic scan function.
Note: Group 3 should only be used in controlled Wi-Fi environments to
prevent interference from unexpected Wi-Fi devices.
Selecting a Group
1. Press and hold the group button for 2 sec-
onds until the group display flashes.
2. Press the group button to scroll through the available groups.
3. The receiver will automatically save the selected group.
Selecting a Channel
1. Press and hold the channel button for 2 sec-
onds until the channel display flashes.
2. Press the channel button to scroll through the available channels.
3. The receiver will automatically save the selected channel.
Note: A double dash symbol-- displayed on the receiver screen during
a channel scan indicates that there are no available channels within the
selected group. Choose a group with more channels and repeat set up
steps.
Firmware
Firmware is embedded software in each component that controls function-
ality. Periodically, new versions of firmware are developed to incorporate
additional features and enhancements. To take advantage of design
improvements, new versions of the firmware can be downloaded and in-
stalled using the Shure Update Utility tool.
Software is available for download from http://www.shure.com/
update-utility.
Connect to the Computer
Connect the device to your computer using the USB to Micro USB cable
supplied with your GLX-D system.
11